Home

Pressure Washers Maintenance Tips

Most times, pressure washers don’t usually require a strict maintenance. But If in case your pressure washer has run into certain problems, you can visit Unimanix pressure washer repair. However, the little amount of maintenance can save a lot of money in the long run. An engine is connected to the pump through two (2) parallel lines inside the washer. As the engine is running, the pump becomes active, in order to get water pressurized out of the nozzle or hose.

Proper maintenance of the pump also helps in maintaining the engine, keeping the whole machine running effectively and smoothly. Below are some tips for maintaining your pressure washer:

#1: Change the oil regularly

Ensure to have the oil within the pressure washer changed regularly in order to have it running smoothly. Just like the oil in a car, the oil within the washer makes sure it’s parts move smoothly without any form of friction. In the process, the oil picks up dirt, which makes usage more difficult, and most times thickens the oil. The oil in the pressure washer should be changed every month.

When changing the oil, drain all fuel and oil from the washer’s engine by using an Allen wrench to get the oil cap out. By tilting the washer forward, you can get all used oil in a plastic container. Check the oil for any off whitish color or bubbles. If either of these is present, then a blown seal may exist.

#2: Check for drips and belts

There are two belts that run parallel from the washer pump to its engine. Make sure these belts are unworn, tight, and running smoothly. In the process of checking these belts, look out for any water drippings. Know that leaks can lead to major PSI issues at the pose or nozzles. Use a Teflon tape amply around all the fittings when you are fixing leaks, so as to reduce rust and make sure future separation is done with ease.

#3: Keep contaminants out

Contaminants can clog the pump nozzles or hoses, and valves that create an overwhelming pressure within the pump. Such pressure can get very dangerous. Prepare the tank for usage, if you want to get contaminants out of the water tank.

Ensure to remove any wands or attachments from the spray gun. Get the water supply turned on and hold on to the spray trigger until the water forms a stream that is steady. Continue with the stream for at least two minutes of water flow. Make sure the spray wand is attached and the trigger safety latch is engaged.